Anycubic DLP Craftsman Resin 1L (Aqua Blue)

Usage Notes:

Take a full shake before use in order to have a fully mix the functional components and fully mix the color paste in the resin. Otherwise, uneven coloring of the print may occur.

Unscrew the cap and add it to the resin tank according to requirements, and select the right settings when using.

After printing, use supporting tools for post-processing, including spatula, diagonal pliers, tweezers, containers, and gloves, Ethanol (≥95%), lactate or isopropyl alcohol cleaning liquid.

*It is not recommended to pour the cleaning waste liquid directly into the sewer. It is recommended that the residual resin be treated by light curing after outdoor evaporation or heating to evaporate the water.

Precautions:

1.Keep sealed and away from light at room temperature. Avoid heat or sunlight.

2.Recommended temperature: 18-35℃. The printing effect may be affected if the temperature is too low. The resin can be preheated properly (not more than 60℃) before use.

3.In case of settlement of resin pigment, please stirring or shaking well before use.

4.In order to ensure the desired properties of cured materials, the intensity and time of light source during post-curing should be controlled.Therefore, it is suggested that:

(1)The intensity of mercury lamp or LED light source is 5-10MW /m2, and the duration shall not exceed 1 hour (self-regulation);

(2)The duration of sun exposure (summer) should be controlled at about 1 hour;

(3)Close or long-term exposure under strong light sources such as high-power high-pressure mercury lamp is prohibited;

(4)It is recommended to print in a dark room, or cover when printing.